LEMON Manuals: Even more car manuals for everyone

Installation Procedure

    Fig 1: View Of Clutch Release Cylinder, Bolts And Transaxle
    GM1255813Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  1. Connect the release cylinder to the transaxle and install the bolts.

    Tighten:  Tighten the release cylinder bolts to 60 N.m (44 lb ft)  .

  2. Fig 2: View Of Clutch Release Cylinder, Hose And Bolt
    GM1255812Courtesy of GENERAL MOTORS CORP.
  3. Connect the hose assembly to the cylinder body.
  4. Apply grease where the pushrod connects to the release lever. Be careful not to stain the boot.
  5. Bleed the air. Refer to Hydraulic Clutch Bleeding .
  6. Adjust the clutch pedal. Refer to Clutch Pedal Free Travel Adjustment .
  7. Fill the reservoir with clutch/brake fluid up to the MAX level.
  8. Connect the negative battery cable.