LEMON Manuals: Even more car manuals for everyone

Installation Procedure

    Fig 1: View Of Locking Washer And Piston Rod Bolt
    GM1255790Courtesy of GENERAL MOTORS CORP.
  1. Install the clutch pedal to the mount brace. Make sure the return spring engages the notch on the rear of the clutch pedal.
  2. Coat the piston rod bolt with multi-purpose grease.
  3. Install the piston rod bolt and the locking washer.
  4. Fig 2: View Of Pedal Mounting Shaft, Washer And Nut
    GM1255789Courtesy of GENERAL MOTORS CORP.
  5. Coat the pedal mounting shaft with multi-purpose grease.
  6. NOTE: Refer to Fastener Notice in Cautions and Notices.
  7. Install the pedal mounting shaft, the washer, and the nut.

    Tighten:  Tighten the clutch pedal nut to 18 N.m (13 lb ft)  .

  8. Fig 3: View Of Mount Brace And Return Spring
    GM1255788Courtesy of GENERAL MOTORS CORP.
  9. Connect the return spring to the mount brace.
  10. Connect the negative battery cable.