Installation Procedure
- Lubricate the new seals with grease.
- Apply a single layer of tape to the pitman shaft in order to avoid damaging the seals.
- Install the pitman shaft oil seal (2) and washer (3) to the power steering gear.
- Use the J 6219
to install the pitman shaft seal and washer to the power steering gear. See Special Tools .
The seal should be in far enough to install the return ring, dust seal, and the snap ring.
- Install the return ring and the dust seal to the power steering gear.
- Use J 6219 in order to seat the return ring and the dust seal in the power steering gear. See Special Tools .
- Install the snap ring to the pitman shaft using J 4245 . See Special Tools .
- Install the pitman arm. Refer to Pitman Arm Replacement (RWD) or Pitman Arm Replacement (AWD) in Steering Linkage.