Test Description
The numbers below refer to the step numbers on the diagnostic table.
- 2: Lack of communication may be due to a partial malfunction of the class 2 serial data circuit or due to a total malfunction of the class 2 serial data circuit. The specified procedure will determine the particular condition.
- 5: The presence of DTCs which begin with U indicate some other module is not communicating. The specified procedure will compile all the available information before tests are performed.
Diagnostic System Check - Door Systems
| Step | Action | Yes | No |
|---|---|---|---|
| 1 | Install a scan tool. Does the scan tool power up? |
Go to Step 2 | Go to Scan Tool Does Not Power Up in Data Link Communications |
| 2 |
|
Go to Step 4 | Go to Scan Tool Does Not Communicate with Class 2 Device in Data Link Communications |
| 3 |
IMPORTANT:
The engine may start during the following step. Turn OFF the engine as soon as you have observed the Crank power mode.
|
Go to Step 4 | Go to Power Mode Mismatch in Body Control System |
| 4 | Select the display DTCs function on the scan tool for the following modules:
Does the scan tool display any DTCs? |
Go to Step 5 | Go to Symptoms - Doors |
| 5 | Does the scan tool display any DTCs which begin with a U? | Go to Scan Tool Does Not Communicate with Class 2 Device in Data Link Communications | Go to Step 6 |
| 6 | Does the scan tool display DTC B1000, B1339 or B1349? | Go to Diagnostic Trouble Code (DTC) List in Body Control System | Go to Step 7 |
| 7 | Does the scan tool display any DTCs which begin with a P? | Go to Diagnostic Trouble Code (DTC) List (3.4L) or Diagnostic Trouble Code (DTC) List (3.8L) in Engine Controls | Go to Step 8 |
| 8 | Does the scan tool display one of the following DTCs?
|
Go to Diagnostic Trouble Code (DTC) List | Go to Symptoms - Doors |