LEMON Manuals: Even more car manuals for everyone

Test Description

The numbers below refer to the step numbers in the diagnostic procedures.

  1. The numbers below refer to the step numbers on the diagnostic procedures.
  2. 1 -  Make sure you perform the I/M System Check before performing this test. Failure to do so may result in difficulty updating the status to YES.
  3. 2 -  This step is to run the HO2S Heater Tests. Preprogramming the scan tool will reduce the amount of time the oxygen sensor heaters operate while verifying the enable criteria.
  4. 3 -  This step is to run the Catalyst Test. The Catalyst Test runs during the specified cruise period.
  5. 4 -  This step is to run the Exhaust Gas Recirculation (EGR) tests. A steady vehicle speed is required in order to maintain a high, stable signal from the Manifold Absolute Pressure (MAP) sensor.
  6. 5 -  This step is to run the oxygen sensor tests.
  7. 6 -  This step is to run the EVAP tests.
  8. 8 -  The I/M System Status only reports on whether or not a diagnostic has run, not the outcome of the test. If any emission related DTC sets after the tests are complete, the DTC will require diagnosis.