Diagnostic Procedures
- Perform diagnostic system check - engine controls. See DIAGNOSTIC SYSTEM CHECK - ENGINE CONTROLS under SELF-DIAGNOSTIC SYSTEM. After performing diagnostic system check - engine controls, go to next step.
- Check for a MAP sensor DTC. Is a Current or Pending DTC P0107 or P0108 set? If yes, DTC P0107: MANIFOLD ABSOLUTE PRESSURE SENSOR CIRCUIT - LOW VOLTAGE or DTC P0108: MANIFOLD ABSOLUTE PRESSURE SENSOR CIRCUIT - HIGH VOLTAGE . If no, go to next step.
- Turn ignition on, with engine off. Clear the scan tool information. Select the MAP sensor parameter on the scan tool. Is MAP sensor pressure reading near 97-100 kPa at sea level? If yes, go to next step. If no, go to step 7 .
- Turn ignition on, with engine off. Compare the pressure readings of the BARO sensor and MAP sensor on the scan tool. Is the difference between the BARO pressure and MAP pressure more than 3 kPa? If yes, go to step 8 . If no, go to next step.
- Turn ignition on, with engine off. Remove DOME fuse for 30 seconds. Install DOME fuse. Reset radio clock time. Operate vehicle within the Freeze Frame conditions or until the DTC P2227 diagnostic test has run. Is DTC P2227 set? If yes, go to next step. If no, go to DIAGNOSTIC AIDS .
- Select the Freeze Frame/Failure Record for the current DTC P2227 on the scan tool. Review the MAP sensor readings in the Freeze Frame/Failure Record. Were the recorded MAP sensor readings normal? If yes, go to step 8 . If no, go to next step.
- Inspect the MAP sensor for a skewed or incorrectly calibrated MAP sensor, blockage or restriction in the MAP sensor vacuum supply or electrical resistance in the MAP sensor signal circuit. Repair as necessary. After repairs, go to step 9 .
- Replace PCM. Perform PCM relearn procedure. See POWERTRAIN CONTROL MODULE under PROGRAMMING. After replacing PCM, go to next step.
- Turn ignition off. Remove DOME fuse for 30 seconds. Install DOME fuse. Reset radio clock time. Operate vehicle within the Conditions for Running the DTC or until the DTC P2227 diagnostic test has run. See CONDITIONS FOR RUNNING DTC . Does the DTC run and pass? If yes, go to next step. If no, go to step 2 .
- Using scan tool, observe stored information and Capture Info. Does the scan tool display any DTCs that you have not diagnosed? If yes, diagnose affected DTCs. See DIAGNOSTIC TROUBLE CODE DEFINITIONS . If no, system is okay.