Diagnostic Aids
The IAC Motor Command parameter of the scan tool will appear fixed when a Current or Pending DTC P0505 is set. Clear the DTC in order to observe present time IAC Motor Command readings.
The volume of air measured by the MAF sensor at idle, should be nearly equal to the volume of air supplied by the IAC system. A DTC P0505 can set if the MAF sensor indicates that the measured volume of air flow at idle is significantly more than the Calculated IAC Air Flow. Inspect the IAC system for a binding or malfunctioning IAC valve, an air leak into the idle air bypass passage, bent or damaged throttle plate, faulty or incorrectly calibrated Mass Airflow (MAF) sensor.
If the DTC P0505 is intermittent, driving the vehicle under the following conditions can verify whether the fault is present. Perform the scan tool Clear DTC Information function. Road test the vehicle while monitoring the DTC P0505 diagnostic on the scan tool under the Not Ran Since Code Cleared selection in the DTC Information menu. If DTC P0505 appears in the Not Ran Since Code Cleared list, the DTC P0505 diagnostic has not yet run. When the DTC P0505 does not appear in the Not Ran Since Code Cleared list, the DTC P0505 diagnostic has run. If the MIL is NOT illuminated, and there is no Pending DTC Status in DTC Information, the DTC P0505 diagnostic has passed. The DTCs MUST be cleared in order to view the Current Status of the Not Ran Since Code Cleared list. DO NOT forget that the Not Ran Since Code Cleared list only indicates that the test has run, not whether the test passed or failed. The DTC Information screen must be checked for Current or Pending status in order to determine the outcome of the diagnostic test involved.
An intermittent malfunction may be caused by a fault in the IAC system electrical circuits. Check the wiring harness and components for an intermittent condition. See INTERMITTENTS in TROUBLE SHOOTING - NO CODES - 2.0L & 2.5L TRACKER article.