LEMON Manuals: Even more car manuals for everyone

Diagnostic Procedures

  1. Perform diagnostic system check - engine controls. See DIAGNOSTIC SYSTEM CHECK - ENGINE CONTROLS  under SELF-DIAGNOSTIC SYSTEM. After performing diagnostic system check - engine controls, go to next step.
  2. Check for objects blocking the MAF sensor inlet screen, intake manifold vacuum leaks, throttle body vacuum leaks, EGR valve leaks, or faulty, missing or incorrectly installed PCV valve. Repair as necessary. Was a repair necessary? If yes, go to step  13 . If no, go to next step.
  3. Turn ignition on, with engine off. Use the scan tool Clear Information function. Operate the vehicle within the Freeze Frame conditions. Is DTC P0101 set? If yes, go to next step. If no, go to DIAGNOSTIC AIDS  .
  4. Turn ignition off. Disconnect the MAF sensor electrical connector. Turn ignition on, with engine off. Probe the MAF sensor ignition feed circuit at the MAF sensor harness connector using a test light connected to ground. Is the test light illuminated? If yes, go to next step. If no, go to step  9 .
  5. Connect the test light between the MAF sensor ignition feed circuit and the ground circuit at the MAF sensor harness connector. Is the test light illuminated? If yes, go to next step. If no, go to step  10 .
  6. Turn ignition off. Reconnect the MAF sensor connector. Turn ignition on, with engine off. Backprobe the MAF sensor signal circuit at the PCM using a DVOM. Measure the voltage. Is the voltage within 1.5-1.8 V? If yes, go to next step. If no, go to step  8 .
  7. Check for a poor connection at the MAF sensor and at the PCM connectors. Repair as necessary. Was a repair necessary? If yes, go to step  13 . If no, go to step  12 .
  8. Check the MAF sensor signal circuit for an open between the PCM and the MAF sensor, a short between the PCM and the MAF sensor, or a poor connection at the MAF sensor. Repair as necessary. Was a repair necessary? If yes, go to step  13 . If no, go to step  11 .
  9. Locate and repair the open circuit in the ignition feed circuit to the MAF sensor. After repairs, go to step  13 .
  10. Locate and repair the open circuit in the ground circuit to the MAF sensor. After repairs, go to step  13 .
  11. Replace the MAF sensor. After repairs, go to step  13 .
  12. Turn ignition off. Replace PCM. Perform PCM relearn procedure. See POWERTRAIN CONTROL MODULE  under PROGRAMMING. After replacing PCM, go to next step.
  13. Turn ignition off. Remove DOME fuse for 30 seconds. Install DOME fuse. Reset radio clock time. Start engine. Operate the vehicle within the Conditions for Running the DTC or until the DTC P0101 diagnostic test has run. See CONDITIONS FOR RUNNING DTC  . Does the DTC run and pass? If yes, go to next step. If no, go to step  2 .
  14. With a scan tool, observe the stored information, Capture Info. Does the scan tool display any DTCs that you have not diagnosed? If yes, see DIAGNOSTIC TROUBLE CODE DEFINITIONS  . If no, system is okay.