LEMON Manuals: Even more car manuals for everyone

Removal Procedure

  1. On California 2.0L engine, remove 5 upper exhaust manifold heat shield bolts.
  2. Remove the upper exhaust manifold heat shield.
  3. Remove 3 exhaust manifold to front pipe nuts (1).
    Fig 1: Removing Exhaust Manifold To Front Pipe Nuts
    G01471733Courtesy of GENERAL MOTORS CORP.
  4. On all, raise and support the vehicle. Refer to LIFTING & JACKING VEHICLE in General Information.
  5. On California 2.0L engine, remove the heated oxygen sensor (HO2S2). Refer to HEATED OXYGEN SENSOR (HO2S) 2 REPLACEMENT (W/ PUP-TWC) or HEATED OXYGEN SENSOR (HO2S) 2 REPLACEMENT (W/O PUP-TWC) in Engine Controls-2.0L.
  6. Remove 1 bolt and 1 nut from the exhaust manifold pipe bracket.
    Fig 2: Removing Bolt & Nut From Exhaust Manifold Pipe Bracket
    G01471734Courtesy of GENERAL MOTORS CORP.
  7. On all, remove 2 bolts and the front pipe/TWC assembly (2) from the exhaust manifold (1).
    Fig 3: Removing Bolts & Front Pipe/TWC Assembly From Exhaust Manifold
    G01471735Courtesy of GENERAL MOTORS CORP.
  8. On non-California 2.0L engine, remove the electrical connector at the heated oxygen sensor (HO2S2) (6).
    Fig 4: Removing Electrical Connector At Heated Oxygen Sensor (HO2S2)
    G01471736Courtesy of GENERAL MOTORS CORP.
  9. On all, remove two nuts and the front pipe/TWC assembly (1) from the resonator/muffler/tail pipe assembly.
  10. Remove the hanger supporting the TWC.
  11. Remove the front pipe/TWC assembly (1) from the vehicle.
  12. Clean the gasket and the seal mating surfaces.
    Fig 5: Removing Front Pipe/TWC Assembly From Vehicle
    G01471737Courtesy of GENERAL MOTORS CORP.