Diagnostic Procedures
- Perform diagnostic system check - engine controls. See DIAGNOSTIC SYSTEM CHECK - ENGINE CONTROLS under SELF-DIAGNOSTIC SYSTEM. After performing diagnostic system check - engine controls, go to next step.
- Turn ignition on, with engine off. Perform the scan tool Clear DTC Information function. Start the engine. Run the engine for 3 minutes or more. If the MIL is not illuminated, turn OFF the engine and repeat the prior two steps. Is DTC P1500 set? If yes, go to next step. If no, see DIAGNOSTIC AIDS .
- Turn OFF ignition. Disconnect the PCM electrical connectors. Turn ignition on, with engine off. Place the gear selector in Park or Neutral. Measure the start signal circuit voltage with a Digital Multimeter (DMM). Crank the engine. If necessary depress the clutch pedal fully while cranking. Measure the start signal circuit voltage with a DMM while cranking the engine. Does the voltage equal 0 volts with the ignition ON, and within the 6-12 volts range while cranking the engine? If yes, go to step 5 . If no, go to next step.
- Repair the open or the short in the crank signal circuit between the PCM and the CPP switch. After repairs, go to step 7 .
- Check for faulty electrical connections at the PCM. Repair as necessary. Was a repair necessary? If yes, go to step 7 . If no, go to next step.
- Replace PCM. Perform PCM relearn procedure. See POWERTRAIN CONTROL MODULE under PROGRAMMING. After replacing PCM, go to next step.
- Turn OFF ignition. Remove DOME fuse for 30 seconds. Install the DOME fuse. Reset the radio clock time. Start the engine. Operate the vehicle within the Conditions for Running the DTC or until the DTC P01500 diagnostic test has run. See CONDITIONS FOR RUNNING DTC . Does the DTC run and pass? If yes, go to next step. If no, go to step 2 .
- Using scan tool, observe stored information and Capture Info. Does the scan tool display any DTCs that you have not diagnosed? If yes, see DIAGNOSTIC TROUBLE CODE DEFINITIONS . If no, system is okay.