Test Description
The numbers below refer to the step numbers in the diagnostic procedures.
- 1
The Diagnostic System Check - Engine Controls prompts the technician to complete some basic checks and store the Freeze Frame data on the scan tool, if applicable. This creates an electronic copy of the data taken when the fault occurred. The information is then stored in the scan tool for later reference. - 2
This step checks that the BARO sensor is reading atmospheric pressure. Normal atmospheric pressure will be near 100 kPa at sea level. - 3
This step checks that the MAP sensor reading and the BARO sensor reading are almost equal. When the engine is not running intake manifold pressure and atmospheric pressure should be the same, therefore both sensors should indicate approximately the same pressure. Normal atmospheric pressure will be near 100 kPa at sea level. When the engine is not running intake manifold pressure and atmospheric pressure should be the same. - 6
Clearing the DTCs by removing the DOME fuse also clears the PCM long term memory. Using the scan tool to clear DTCs leaves the long term memory active. DTC emitting diagnostics may not run to completion as expected unless the long term memory is cleared. Removal of the DOME fuse also clears the time display of the radio.