Diagnostic Procedures
- Perform diagnostic system check - engine controls. See DIAGNOSTIC SYSTEM CHECK - ENGINE CONTROLS under SELF-DIAGNOSTIC SYSTEM. After performing diagnostic system check - engine controls, go to next step.
- Check for any of the following conditions: Objects blocking the MAF sensor inlet screen, intake manifold vacuum leaks, throttle body vacuum leaks, EGR valve leaks, or faulty, missing or incorrectly installed PCV valve. Repair as necessary. Was a repair necessary? If yes, go to step 13 . If no, go to next step.
- Turn ignition on, with engine off. Use the scan tool Clear Information function. Operate the vehicle within the Freeze Frame conditions. Is DTC P0101 set? If yes, go to next step. If no, go to DIAGNOSTIC AIDS .
- Turn OFF ignition. Disconnect the MAF sensor electrical connector. Turn ignition on, with engine off. Probe the MAF sensor ignition feed circuit at the MAF sensor harness connector using a test light connected to ground. Is the test light illuminated? If yes, go to next step. If no, go to step 9 .
- Connect the test light between the MAF sensor ignition feed circuit and the ground circuit at the MAF sensor harness connector. Is the test light illuminated? If yes, go to next step. If no, go to step 10 .
- Turn OFF ignition. Reconnect the MAF sensor connector. Turn ignition on, with engine off. Backprobe the MAF sensor signal circuit at the PCM using a DMM. Measure the voltage. Is the voltage within 1.5-1.8 V? If yes, go to next step. If no, go to step 8 .
- Check for a poor connection at the MAF sensor and at the PCM connectors. Repair as necessary. Was a repair necessary? If yes, go to step 13 . If no, go to step 12 .
- Check the MAF sensor signal circuit for an open between the PCM and the MAF sensor, a short between the PCM and the MAF sensor, or a poor connection at the MAF sensor. Repair as necessary. Was a repair necessary? If yes, go to step 13 . If no, go to step 11 .
- Locate and repair the open circuit in the ignition feed circuit to the MAF sensor. After repairs, go to step 13 .
- Locate and repair the open circuit in the ground circuit to the MAF sensor. After repairs, go to step 13 .
- Replace the MAF sensor. After repairs, go to step 13 .
- Turn ignition off. Replace PCM. Perform PCM relearn procedure. See POWERTRAIN CONTROL MODULE under PROGRAMMING. After replacing PCM, go to next step .
- Turn OFF ignition. Remove DOME fuse for 30 seconds. Install the DOME fuse. Reset the radio clock time. Start the engine. Operate the vehicle within the Conditions for Running the DTC or until the DTC P0101 diagnostic test has run. See CONDITIONS FOR RUNNING DTC . Does the DTC run and pass? If yes, go to next step. If no, go to step 2 .
- With a scan tool, observe the stored information, Capture Info. Does the scan tool display any DTCs that you have not diagnosed? If yes, see DIAGNOSTIC TROUBLE CODE DEFINITIONS . If no, system is okay.