LEMON Manuals: Even more car manuals for everyone

Removal Procedure

  1. Turn the ignition switch to the OFF position.
  2. Disconnect the EBCM harness connector.
  3. Remove the BPMV pump motor ground wire.
  4. Remove the brake pipes from the master cylinder to the BPMV (1, 2), noting the location.
    Fig 1: Removing Master Cylinder To BPMV Brake Pipes
    G01728621Courtesy of GENERAL MOTORS CORP.
  5. Remove the brake pipes from the BPMV (1, 2) to the front brake calipers, noting the location.
    Fig 2: Removing Front Brake Caliper To BPMV Brake Pipes
    G01728622Courtesy of GENERAL MOTORS CORP.
  6. Remove the brake pipes from the BPMV (1, 2) to the rear brake calipers, noting the location.
    Fig 3: Removing Rear Brake Caliper To BPMV Brake Pipes
    G01728623Courtesy of GENERAL MOTORS CORP.
  7. Disconnect the electrical connector from the brake fluid pressure sensor (2).
  8. Remove the two insulator nuts (1).
  9. Remove the EBCM/BPMV from the vehicle as one unit.
    Fig 4: Disconnecting Brake Fluid Pressure Sensor Electrical Connector
    G01728624Courtesy of GENERAL MOTORS CORP.
  10. Remove the insulator mounting bolt from the EBCM.
  11. Remove the four EBCM to BPMV bolts.
  12. Separate the EBCM from the BPMV by gently pulling apart until separated.
  13. Carefully remove the seal.

    The seal may be reused if it is not cut or damaged.

    Fig 5: Removing EBCM Bolts
    G01728625Courtesy of GENERAL MOTORS CORP.