Throttle Valve (T.V.) Cable
- Ensure accelerator cable is adjusted. Accelerator cable should have .02-.08" (.51-2.0 mm) clearance between throttle lever and throttle stop with accelerator pedal at idle position and engine off.
- Warm engine to normal operating temperature. Ensure base idle speed is set to specification. Turn engine off. Remove T.V. cable cover. Check boot-to-inner cable stopper clearance. See Fig 1.
- If clearance is greater than .04" (1.0 mm), loosen lower adjustment lock nuts and adjust cable length. If T.V. cable adjusting nuts do not provide enough adjustment, use accelerator cable adjusting nuts to change cable length. Tighten all lock nuts after adjustment.
Courtesy of GENERAL MOTORS CORP.