Mil On Steady
- Perform POWERTRAIN ON-BOARD DIAGNOSTIC (OBD) SYSTEM CHECK , then go to next step.
- Turn ignition on with engine off. MIL should illuminate. If MIL does not illuminate, go to MIL INOPERATIVE. If MIL illuminates, go to next step.
- Install scan tool. Using scan tool, command MIL on and off. If MIL turns on and off when commanded, go to step 8). If MIL does not turn on and off when commanded, go to next step.
- Turn ignition off. Disconnect PCM connectors. Turn ignition on. If MIL does not illuminate, go to step 7). If MIL illuminates, go to next step.
- Check for short to ground in MIL control circuit. See ENGINE PERFORMANCE WIRING DIAGRAMS - 2.2L article. Repair as necessary. After repairs, go to step 8). If circuit is okay, go to next step.
- Replace Instrument Panel Cluster (IPC). After IPC replacement, go to step 8).
- Replace PCM. Perform PCM relearn procedures. After repairs, go to next step.
- Using scan tool, clear DTCs. Attempt to start engine. If engine starts and runs, go to next step. If engine does not start, or starts and dies, go to step 1).
- Warm engine to operating temperature. Check for DTCs. If DTCs are present, see TROUBLE CODE DEFINITION table. If DTCs are not present, system is okay.