LEMON Manuals: Even more car manuals for everyone

DTCS 21/22, TP Sensor Circuit High/Low (4L80-E With TCM): Notes

TP sensor contains a resistor strip with one end connected to a 5-volt supply and other to ground. Signal circuit is connected to a movable contact within TP sensor. As accelerator pedal is applied, voltage signal will increase from about .5 volt to 4.5 volts.

DTC 21 will set when:

DTC 22 will set when:

TCM will default to maximum line pressure, use 35 percent throttle as default, and inhibit 4th gear if in hot mode.

NOTE: Test numbers refer to numbers on diagnostic chart.
  1. This test checks for presence of 5 volts at TP sensor.
  2. Scan tester should display 5-volt reference to TCM.