LEMON Manuals: Even more car manuals for everyone

Inner Tie Rod End: Installation

  1. To install, ensure all surfaces are clean. Install shock dampener ring onto rack. Place wrenches on flats of rack and inner tie rod housing. See Figure . Install inner tie rod onto rack. Ensure tie rod rocks freely in housing before staking inner tie rod assembly to rack. Support rack and inner tie rod housing.
  2. Stake both sides of inner tie rod housing to flats on rack. Insert .01" (.25 mm) feeler gauge between rack and tie rod housing stake. Feeler gauge must not pass between rack and housing stake.
  3. Slide and engage shock damper ring over inner tie rod housing. Lubricate boot contact areas on inner tie rod end and housing with grease before installing boot. Install boot and breather tube, aligning reference mark with mark on housing. Install NEW boot seal clamps. Using Clamp Pliers (J-22610), tighten boot clamps. Ensure boot is not twisted or puckered.
  4. To complete installation, reverse removal procedure. Tighten bolts and nuts to specifications. See TORQUE SPECIFICATIONS  table at end of article.