LEMON Manuals: Even more car manuals for everyone

Ball Stud

NOTE: This procedure is for vehicles with cable operated clutch, after cable or clutch has been replaced.
  1. With release bearing, clutch fork and ball stud installed, place gauge (J-28449) so flat end is against front face of clutch housing and hooked end is aligned with bottom depression in clutch fork. See Fig 2
  2. Turn ball stud clockwise by hand until release bearing makes contact with clutch spring and fork is snug on gauge. Install lock nut and tighten, being careful not to change ball stud adjustment. Remove gauge by pulling outward at housing end.
Fig 1: Exploded View of General Motors Diaphragm Spring Clutch Assembly
G26006
Fig 2: Chevette & T1000 Ball Stud Adjustment
G26005