LEMON Manuals: Even more car manuals for everyone

4-Cyl. Engines

  1. Rotate crankshaft until No. 1 piston reaches TDC of compression stroke. Remove upper timing belt cover. Check to make sure that timing belt is properly tensioner and that timing marks are aligned.
  2. Remove camshaft cover. Check for alignment of slot on rear of camshaft to camshaft cover mounting surface using alignment tool (J-29761).
  3. Remove injector lines, distributor head screw and washer. Install static timing gauge (J-29763) and set lift at about 0.04" from plunger. Rotate crankshaft to bring No. 1 piston to 45-60° BTDC. Zero dial indicator.
  4. Rotate crankshaft (in normal direction of travel) until 18° mark on pulley lines up with pointer. See Fig 1. Observe dial indicator reading. If dial indicator reading is not 0.02", timing requires adjustment.
    Fig 1: 1.8L Crankshaft Dampener Pulley Timing Notches
    G09318054Courtesy of GENERAL MOTORS COMPANY
  5. To adjust timing, hold crankshaft at 18° BTDC, loosen 2 nuts on injection pump flange and rotate pump until dial indicator reads 0.02". Tighten pump flange nuts, recheck dial indicator reading and readjust as necessary.
  6. Remove timing gauge and replace distributor screw and washer. Install camshaft cover, injection lines and fuel filter.