Installation Procedure
-
Install the retainers that hold the battery cable harness to the battery tray.
- Install the battery cable harness retainer to the engine block and tighten the fastener (4) to 25 N.m (18 lb ft).
- Install the negative battery cable terminal and fastener (3) to the left rear cylinder head. Tighten to 25 N.m (18 lb ft).
- Install the battery positive cable terminal and fastener (2) to the starter solenoid. Tighten to 9 N.m (80 lb in).
- Install the starter heat shield and tighten to 5 N.m (44 lb in).
- Install the battery positive cable terminal and fastener (1) to the back of the generator. Tighten to 15 N.m (11 lb ft).
Install the battery negative cable terminal (2) and fastener (1) to the left front frame rail. Tighten to 9 N.m (80 lb in).
Install the positive battery cable terminal and fastener (2) to the battery fuse block. Tighten to 12 N.m (106 lb in).
- Close battery fuse block cover (1) and install battery negative cable. Refer to Battery Negative Cable Disconnection and Connection .
CAUTION:
Refer to Fastener Caution .