LEMON Manuals: Even more car manuals for everyone

Circuit/System Verification

  1. Ignition ON.
  2. Verify that no ignition, starter relay, brake pedal position sensor, immobilizer, engine, or automatic transmission DTCs are set that would cause the ECM to disable engine starting.
    • Go to next step: If no DTCs are set 
  3. Verify the scan tool BCM 5 V Ignition Switch (vehicles without push button start) or ECM Power Mode (vehicles with push button start) parameter is Crank Request while attempting to start the vehicle.
    • Go to next step: If parameter displays Crank Request 
  4. Verify the scan tool TCM Internal Mode Switch parameter displays Park with the transmission range selector in park.
    • Go to next step: If the TCM Internal Mode Switch parameter indicates Park 
  5. Verify the scan tool ECM Crankshaft Position Active Counter parameter is not incrementing.
    • If the counter increments 

      Replace the B26 Crankshaft Position Sensor.

    • Go to next step: If the counter does not increment 
  6. Verify the KR27 Starter Relay clicks and the engine begins cranking with the ignition activated to Crank.
    • If the KR27 Starter Relay does not click 

      Refer to Circuit/System Testing.

    • Go to next step: If the KR27 Starter Relay clicks 
  7. All OK.