LEMON Manuals: Even more car manuals for everyone

Rear Side Door Window Weatherstrip Replacement

Fig 1: Rear Side Door Window Weatherstrip
GM3417978Courtesy of GENERAL MOTORS COMPANY
Callout Component Name

Preliminary Procedures

  1. Remove the rear side door window garnish molding. Refer to Rear Side Door Window Garnish Molding Replacement .
  2. Remove the rear side door window inner strip. Refer to Rear Side Door Window Inner Sealing Strip Replacement .
  3. Remove the rear side door window reveal molding. Refer to Rear Side Door Window Belt Reveal Molding Replacement .
  4. Remove the rear side door window inside sunshade. Refer to Rear Side Door Window Inside Sunshade Replacement .
1 Rear Side Door Window Weatherstrip Screw
CAUTION: Refer to Fastener Caution .

Tighten 
2.5 N.m (22 lb in)
2 Rear Side Door Stationary Window Divider Channel Lower Support Bolt

Procedure

  1. Apply masking tape to the applique, outer belt reveal molding and door frame.
  2. Position the window all the way down in the door.

Tighten 
11.5 N.m (102 lb in)
3 Rear Side Door Window Weatherstrip

Procedure

  1. Start in the top upper rear corner of the door frame, pull the weatherstrip out of the door frame and rear window channel.
  2. Install the window weatherstrip to the top upper rear corner of the door frame, work the weatherstrip around the upper door frame and then down both front lower channels.
  3. Ensure that the weatherstrip is fully seated into the upper door frame and down both front lower channels.
NOTE: Inspect the door window for proper operation before installing the door trim.