LEMON Manuals: Even more car manuals for everyone

Circuit/System Testing

  1. Disconnect the harness connector at the adjustable pedal switch.
  2. Ignition ON, test for 11.8-12.2 volts between the appropriate 12-volt reference circuit listed below and ground:
    • X88/Z88 - terminal 11
    • Z75 - terminal 5
    • If greater than the specified range, test the 12-volt reference circuit for a short to voltage. If the circuit tests normal, replace the MSM.
    • If less than the specified range, test the 12-volt reference circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the MSM.
  3. Verify the scan tool Pedal Forward Switch parameter is Inactive.
    • If not the specified value, test the appropriate signal circuit terminal listed below for a short to voltage. If the circuit tests normal, replace the MSM.
      • X88/Z88 - terminal 12
      • Z75 - terminal 6
  4. Verify the scan tool Pedal Aft Switch parameter is Inactive.
    • If not the specified value, test the appropriate signal circuit terminal listed below for a short to voltage. If the circuit tests normal, replace the MSM.
      • X88/Z88 - terminal 10
      • Z75 - terminal 4
  5. Install a 3A fused jumper wire between the appropriate signal circuit terminal listed below and B+. The scan tool Pedal Forward Switch parameter should be Active.
    • X88/Z88 - terminal 12
    • Z75 - terminal 6
    • If not the specified value, test the signal circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the MSM.
  6. Install a 3A fused jumper wire between the appropriate signal circuit terminal listed below and B+. The scan tool Pedal Aft Switch parameter should be Active.
    • X88/Z88 - terminal 10
    • Z75 - terminal 4
    • If not the specified value, test the signal circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the MSM.
  7. If all circuits test normal, test or replace the adjustable pedal switch.