LEMON Manuals: Even more car manuals for everyone

Component Testing

Memory Switch

  1. Disconnect the X4 harness connector at the DDM.
  2. Test for infinite resistance between the memory switch signal circuit terminal 5 and the switch supply voltage circuit terminal 14.
    • If not infinite, replace the memory seat adjuster switch.
  3. Test the resistance between terminal 5 and terminal 14 while pressing the memory 1, memory 2, and EXIT buttons. Compare the resistance readings to the values in the Memory Switch Values table below.
    • If the resistance is not within the specified range, replace the memory seat adjuster switch.
Memory Switch Values

Switch Position Resistance
Idle Infinite
Memory 1 2.03K-2.49K Ω
Memory 2 3.83K-4.69K Ω
EXIT 8.33K-10.18K Ω