LEMON Manuals: Even more car manuals for everyone

Removal Procedure

WARNING: This page is about a different car, the 2007 Cadillac SRX. However, it is still accessible from the selected car via links, so may be relevant.
  1. Check to be sure that the park brake is released.
  2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  3. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
  4. NOTE: Support the brake caliper with heavy mechanic wire, or equivalent, whenever it is separated from its mount and the hydraulic flexible brake hose is still connected. Failure to support the caliper in this manner will cause the flexible brake hose to bear the weight of the caliper, which may cause damage to the brake hose and in turn may cause a brake fluid leak.
    IMPORTANT: Do NOT disconnect the hydraulic brake flexible hose from the caliper.
  5. Remove the brake caliper and the caliper mounting bracket as an assembly from the suspension knuckle and support the assembly with heavy mechanic's wire, or equivalent. Ensure that there is no tension on the hydraulic brake flexible hose. Refer to Rear Brake Caliper Bracket Replacement .
  6. Matchmark the position of the brake rotor to the wheel studs.
  7. Fig 1: View Of Front Brake Rotor
    GM787588Courtesy of GENERAL MOTORS CORP.
  8. Remove the brake rotor mounting screw.
  9. Remove the brake rotor. Do not force the rotor off. If the rotor is difficult to remove, ease it off by gently rotating it as you pull outward.
  10. Fig 2: View Of J-46277 Rotor Removal Tool
    GM1471360Courtesy of GENERAL MOTORS CORP.
  11. If the brake rotor cannot be removed perform the following:
    1. Assemble J-46277  to J 2619-01  . See Special Tools .
    2. Insert J-46277  between the rotor friction surfaces in the vent section of the rotor. See Special Tools .

      DO NOT place the J-46277  on the rotor friction surface. See Special Tools .

    3. Using J-46277  and J 2619-01  remove the rotor from the hub assembly. See Special Tools .
    4. Inspect the park brake components for the following conditions:
      • Bent or broken hold down spring
      • Broken, cracked, or worn brake shoe lining
      • Bent or damaged brake shoe
      • Worn, bent, or damaged backing plate
    5. If any of these conditions are found replace the affected parts.