LEMON Manuals: Even more car manuals for everyone

Test Description

The numbers below refer to the step numbers on the diagnostic table.

  1. 2:  Perform the Steering Position Sensor Test in order to verify that the steering wheel position sensor (SWPS) is operating properly.
  2. 3:  Verify that the Lateral Accelerometer Signal parameter is within the valid range.
  3. 4:  Verify that the Yaw Rate Signal parameter is within the valid range.
DTC C0253

Step Action Values Yes No
Schematic Reference: Anti-Lock Brake System Schematics 
1 Did you perform the Diagnostic System Check - Vehicle? - Go to Step 2  Go to Diagnostic System Check - Vehicle
2 
  1. Install a scan tool.
  2. Turn ON the ignition, with the engine OFF.
  3. With the scan tool, perform the Steering Position Sensor Test.
Did the steering wheel position sensor (SWPS) pass the test?
- Go to Step 3  Go to Step 7 
3  With a scan tool, observe the Lateral Accelerometer Signal parameter in the VSES data list.
Does the scan tool display within the specified range?
2.3-2.7 V Go to Step 4  Go to Step 8 
4  With a scan tool, observe the Yaw Rate Signal parameter in the VSES data list.
Does the scan tool display within the specified range?
2.3-2.7 V Go to Step 5  Go to Step 8 
5
  1. Use the scan tool in order to clear the DTCs.
  2. Perform the Diagnostic Test Drive. Refer to Diagnostic Test Drive .
Does the DTC reset?
- Go to Step 6  Go to Diagnostic Aids
6 Replace the electronic brake control module (EBCM). Refer to Control Module References for replacement, setup, and programming.
Did you complete the replacement?
- Go to Step 9  -
7 Replace the SWPS. Refer to Steering Wheel Position Sensor or Steering Shaft Lower Bearing Replacement .
Did you complete the replacement?
- Go to Step 9  -
8 Replace the yaw rate/lateral accelerometer sensor. Refer to Vehicle Yaw Sensor with Vehicle Lateral Accelerometer Replacement .
Did you complete the replacement?
- Go to Step 9  -
9
  1. Use the scan tool in order to clear the DTCs.
  2. Operate the vehicle within the Conditions for Running the DTC as specified in the supporting text.
Does the DTC reset?
- Go to Step 2  System OK