INTERMITTENTS & Poor Connections
Intermittent failures in electronic systems may be very difficult to detect and accurately diagnose. The modules test for different malfunctions under different vehicle conditions. Perform a thorough test drive in order to detect a repeating fault condition. If system malfunction is not repeated during test drive, a good description of complaint may be useful in locating an intermittent malfunction.
Faulty wires or connections cause most intermittent conditions. When an intermittent condition is suspected, inspect suspected circuits for following conditions:
- Poor mating of connector halves of backed out terminals.
- Improperly formed or damaged terminals.
- Wire chafing.
- Poor wire to terminal connections.
- Dirty or corroded terminals.
- Connector body damage.
History DTCs indicate that modules have previously detected a malfunction. The reason may be either that malfunction is intermittent or that system for which DTC is set for is not currently being operated. For example, rear defogger circuit does not operate until modules detect engine RPM. For this reason, if a module displays history DTCs and malfunction cannot be found easily, try clearing DTCs and manually operating system that DTC applies to using a scan tool. Read DIAGNOSTIC AIDS and CONDITIONS FOR SETTING DTC in each DTC table for specific information.
History DTCs help in diagnosing intermittent fault conditions but may not indicate a faulty module. The module contains reliable components. The components are not likely cause of malfunction. Most system complaints are linked to faulty wiring and connectors, and occasionally to a complaint. Perform a thorough inspection of all related wiring and connectors pertaining to history DTC that is stored.
The following conditions may result in intermittent module operation with no DTCs stored:
- Any conditions which results in interruption of power to a module.
- The battery or ignition voltage is out of range (below 9.0 volts or above 16.0 volts).
- A loose or damaged ground.
- An open or short on serial data line.