LEMON Manuals: Even more car manuals for everyone

Output Cycling Test

  1. This test procedure can be activated in either of the following methods: Enter diagnostics and with code ".7.0" displayed on ECC panel, depress "Instant/Average" button on fuel data panel. If code ".9.5" does not appear, refer to switch test code ".7.8". The other method is to depress "Instant/Average" button while in Engine Data Display, with parameter ".1.3" displayed.
  2. The output cycling test turns ECM's outputs on and off. To enter actuator cycling tests, start engine. Turn engine off and within 2 seconds, turn ignition on. Enter diagnostics and display code ".9.5" on ECC panel. Depress accelerator pedal to wide open throttle position and release pedal. Code ".9.6" should appear. If ".9.6" does not appear, refer to switch test ".7.2".
  3. Turn cruise control instrument panel switch on. Cruise control outputs will cycle. Output cycling tests will automatically end after 2 minutes. The outputs will cycle on and off every 3 seconds until the 2 minute automatic shut-off occurs. The only exception to this cycle is cruise control power valve which cycles continuously.
  4. After cycling output is complete, display should switch from code ".9.6" back to code ".9.5". Additional output cycling may be obtained by pressing and releasing the throttle switch.