Installation Procedure
- NOTE:
Slide the battery to the retainer (1).
Battery (2) - Install
Battery Hold Down Retainer (2) - Install
- Battery Hold Down Bolt (1) - Install and tighten 22 N.m (16 lb ft)
Battery Cover (1) - Install
{If equipped} Electrical Connector (1) @ Retainer (2) - Install
Battery Hold Down Retainer (3) - Install
- Battery Hold Down Retainer Nut (2) - Install and tighten 9 N.m (80 lb in)
- Battery Hold Down Bolt (1) - Install and tighten [2x] 9 N.m (80 lb in)
Engine Control Module Bracket (1) - Install - Engine Control Module Replacement
Battery Distribution Engine Compartment Fuse Block (1) - Install
Retainer (2) - Install
- Battery Positive Post Clamp Nut (1) - Tighten 4.5 N.m (40 lb in)
Battery Distribution Fuse Block Cover (1) - Install
- Retainer (2) - Install [2x]
- Connect the battery negative cable. Battery Negative Cable Disconnection and Connection (2.0L LTG)
CAUTION: