LEMON Manuals: Even more car manuals for everyone

Installation Procedure

  1. GM4620684Courtesy of GENERAL MOTORS COMPANY

    Battery Negative Cable (4) - Install

  2. Battery Negative Cable Bolt (1) - Install and tighten 22 N.m (16 lb ft)
  3. Battery Negative Cable Nut (3) - Install and tighten 9 N.m (80 lb in)
  4. Retainer (2) - Install [2x]
  5. Battery Tray - Install - Battery Tray Replacement 
  6. GM4626856Courtesy of GENERAL MOTORS COMPANY

    Install the battery negative cable (4) to the battery sensor (2).

  7. Carefully install the battery negative cable nut (3) while counterhold with a wrench (1) at the torxpin. Tighten to 9 N.m (80 lb in).
  8. GM4626858Courtesy of GENERAL MOTORS COMPANY

    Remove all dirt, oil and grease from the battery pole (2) and battery sensor (1).

  9. Wide open the battery post negative cable clamp of the battery sensor and install the battery sensor to the battery pole without great force.
  10. Carefully position without great force the battery post negative cable clamp at the bottom of the battery pole as shown in the graphic.
  11. GM4605444Courtesy of GENERAL MOTORS COMPANY

    Battery Post Negative Cable Clamp Nut (2) - Install and tighten 4.5 N.m (40 lb in)

  12. Electrical Connector (1) - Connect
  13. GM4605443Courtesy of GENERAL MOTORS COMPANY

    Battery Terminal Cover (1) - Install

  14. Ignition - On/Vehicle - In Service Mode & Engine - Off
  15. Program the volatile memory. Volatile Memory Programming
  16. Program all of the customer's radio station presets and set the radio clock to the current time.
  17. NOTE:

    Inform customer that the Stop/Start feature will not be available until the vehicle is allowed to sit for at least 3 hours undisturbed.

  18. If diagnosing a stop/start complaint, conduct the battery sensor module learn procedure Control Module References to verify repair.