LEMON Manuals: Even more car manuals for everyone

Circuit/System Testing

  1. Ignition OFF, disconnect the harness connector at the appropriate module/sensor.
  2. Ignition OFF, test for less than 10 Ω between the ground circuit terminals listed below and ground:
    • Terminal H, K83 Parking brake control module
    • Terminal 10, K43 Power steering control module
    • Terminal 13, K17 Electronic brake control module
    • Terminal 38, K17 Electronic brake control module
    • Terminal 18, K19 Suspension control module
    • Terminal E X1, K47 Rear differential clutch control module
    • Terminal L X1, K47 Rear differential clutch control module
    • Terminal 6, B99 Steering wheel angle sensor
    • Terminal 6, B119 Multi-axis acceleration sensor
    • If greater than the specified range, test the ground circuit for an open/high resistance.
  3. Ignition ON, verify a test lamp illuminates between the B+ circuits listed below and ground:
    • Terminal A, K83 Parking brake control module
    • Terminal P, K83 Parking brake control module
    • Terminal 1, K43 Power steering control module
    • Terminal 5, K43 Power steering control module
    • Terminal 1, K17 Electronic brake control module
    • Terminal 25, K17 Electronic brake control module
    • Terminal 1, K19 Suspension control module
    • Terminal 6, K19 Suspension control module
    • Terminal M X1, K47 Rear differential clutch control module
    • Terminal 5, B99 Steering wheel angle sensor
    • Terminal 5, B119 Multi-axis acceleration sensor
    • If the test lamp does not illuminate, test the circuit for an open/high resistance.
  4. If all circuits test normal, replace the appropriate module/sensor.