LEMON Manuals: Even more car manuals for everyone

Component Test

  1. Inspect the CKP sensor for looseness and correct installation.
  2. Disconnect the CKP sensor connector. Connect jumper wires from the CKP sensor connector 12-volt reference CKP sensor terminal D and the low reference CKP sensor terminal C to the CKP sensor. Turn ON the ignition, with the engine OFF.
  3. Ignition ON, connect a DMM to the CKP sensor signal CKP sensor 1 terminal B at the CKP sensor and observe the Duty Cycle. Pass a steel object by the sensor repeatedly. The Duty Cycle should increment.
    • If the Duty Cycle does not increment, replace the CKP sensor.