Installation Procedure
- Install the power steering flow control spring (2) to the power steering pump.
- Install the power steering flow control valve assembly (3) to the power steering pump.
Tighten: Tighten the power steering flow control valve assembly (5) to 75 N.m (55 lb ft).
- Position the power steering pressure hose (3) to the power steering pump, with the 2 NEW washers (2) and install the banjo bolt (1).
Tighten: Tighten the power steering pressure hose banjo bolt to 55 N.m (41 lb ft).
- Lower the vehicle.
- Bleed the power steering system. Refer to Power Steering System Bleeding .
NOTE:
Refer to Fastener Notice
.