Test Description
The numbers below refer to the step numbers on the diagnostic table.
- 2: Listen for an audible click when the automatic transmission shift lock control solenoid operates. Command both the ON and OFF states. Repeat the commands as necessary.
- 3: Verifies that the BCM is providing voltage to the automatic transmission shift lock control solenoid.
- 4: Tests if voltage is constantly being applied to the automatic transmission shift lock control solenoid.
DTC B0803
| Step | Action | Yes | No |
|---|---|---|---|
| Schematic Reference: Automatic Transmission Shift Lock Control Schematics Connector End View Reference: Automatic Transmission Shift Lock Control Connector End Views or Computer/Integrating Systems Connector End Views in Computer/Integrating Systems |
|||
| 1 | Did you perform the Diagnostic System Check - Vehicle? | Go to Step 2 | Go to Diagnostic System Check - Vehicle in Vehicle DTC Information |
| 2 |
|
Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems | Go to Step 3 |
| 3 |
|
Go to Step 4 | Go to Step 6 |
| 4 |
|
Go to Step 8 | Go to Step 5 |
| 5 | Does the test lamp remain illuminated with each command? | Go to Step 10 | Go to Step 7 |
| 6 | Test the park neutral position switch park signal circuit for a short to voltage. Refer to Circuit Testing
and Wiring Repairs
in Wiring Systems. Did you find and correct the condition? |
Go to Step 13 | Go to Step 8 |
| 7 | Test for a open in the A/T shift lock control solenoid supply circuit. Refer to Circuit Testing
and Wiring Repairs
in Wiring Systems. Did you find and correct the condition? |
Go to Step 13 | Go to Step 9 |
| 8 | Inspect for poor connections at the harness connector of the body control module (BCM). Refer to Testing for Intermittent Conditions and Poor Connections
and Connector Repairs
in Wiring Systems. Did you find and correct the condition? |
Go to Step 13 | Go to Step 12 |
| 9 |
|
Go to Step 13 | Go to Step 11 |
| 10 | Repair the short to battery voltage in the A/T shift lock control solenoid supply circuit. Refer to Wiring Repairs
in Wiring Systems. Did you complete the repair? |
Go to Step 13 | - |
| 11 | Replace the A/T shift lock control switch. Refer to Stop Lamp Switch Replacement
in Lighting Systems. Did you complete the replacement? |
Go to Step 13 | - |
| 12 | Replace the BCM. Refer to Control Module References
in Computer/Integrating Systems for replacement, setup, and programming. Did you complete the replacement? |
Go to Step 13 | - |
| 13 |
|
Go to Step 2 | System OK |