LEMON Manuals: Even more car manuals for everyone

Removal Procedure

  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  2. Remove the power steering gear heat shield. Refer to Power Steering Gear Heat Shield Replacement in Power Steering System.
  3. Remove the power steering pressure hose from the rack and pinion and hang from the exhaust pipe. Refer to Power Steering Pressure Pipe/Hose Replacement in Power Steering.
  4. Remove the power steering return hose from the rack and pinion and hang from the exhaust pipe. Refer to Power Steering Return Hose Replacement in Power Steering.
  5. Fig 1: Supporting Transaxle With A Transaxle Support Stand
    GM767120Courtesy of GENERAL MOTORS CORP.
  6. Support the Transaxle with a transaxle support stand.
  7. Remove the rear transaxle mount and bracket bolts then position the mount and bracket aside. Refer to Transmission Mount Bracket Replacement - Rear .
  8. Position a drain pan under the forward servo cover.
  9. Fig 2: Holding Servo Assembly Compressed
    GM767121Courtesy of GENERAL MOTORS CORP.
  10. Using a long screwdriver in order to pry against the vehicle frame. Hold the servo assembly compressed.
  11. Fig 3: View Of Forward Servo Assembly
    GM164777Courtesy of GENERAL MOTORS CORP.
  12. Remove the 3 bolts attaching the servo cover to the transaxle case.
  13. Remove the long screwdriver. The servo assembly will push the servo cover out. If the servo cover does not push out, tap it with a rubber mallet.
  14. Remove the forward servo cover O-ring.
  15. Remove the servo piston assembly.
  16. Remove the servo spring.