LEMON Manuals: Even more car manuals for everyone

Removal Procedure

  1. Remove the drive belt. Refer to Drive Belt Replacement (L36) or Drive Belt Replacement (L67) in Engine Mechanical - 3.8L.
  2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  3. Install a drain pan under the vehicle.
  4. Fig 1: Removing/Installing Power Steering Hose Fitting
    GM254768Courtesy of GENERAL MOTORS CORP.
  5. Disconnect the power steering pressure hose from the power steering pump.
  6. Fig 2: Disconnecting/Reconnecting Power Steering Return Hose At Power Steering Pump
    GM183669Courtesy of GENERAL MOTORS CORP.
  7. Disconnect the power steering return hose from the power steering pump.
  8. Disconnect the wiring harness from the power steering pump.
  9. Remove the antilock brake wiring harness bracket.
  10. Fig 3: Installing The Tie Rod Seal To The Outer Tie Rod Assembly
    GM470653Courtesy of GENERAL MOTORS CORP.
  11. Remove the right outer tie rod retaining nut (3).
  12. Fig 4: Removing Outer Tie Rod Assembly From Steering Knuckle
    GM643351Courtesy of GENERAL MOTORS CORP.
  13. Using J 24319-B  remove the outer tie rod from the steering knuckle. See Special Tools .
  14. Remove the right outer tie rod from the steering knuckle.
  15. Fig 5: Removing/Installing Power Steering Pump Mounting Bolts
    GM464479Courtesy of GENERAL MOTORS CORP.
  16. Remove the power steering pump retaining bolts.
  17. Remove the power steering pump.
  18. Remove the power steering pulley as necessary. Refer to Power Steering Pulley Replacement .
  19. Remove the power steering pump reservoir as necessary. Refer to Power Steering Reservoir Replacement - Off Vehicle (CB Series) .