Diagnostic Aids
The control module runs a maximum of 6 tests per trip until the Catalyst System Status updates to YES. If the status does not update, the test outlined in this procedure may be repeated until the I/M System Status updates to YES.
Inspection/Maintenance (I/M) Catalyst System Set Procedure
| Step | Action | Yes | No |
|---|---|---|---|
| 1 | Did you perform the Inspection/Maintenance (I/M) System Check? | Go to Step 2 | Go to Inspection/Maintenance (I/M) System Check |
| 2 |
CAUTION:
Refer to Road Test Caution
in Cautions and Notices.
IMPORTANT:
In order for this test to run, the vehicle must operate in the following conditions:
|
Go to Step 5 | Go to Step 3 |
| 3 | Observe the DTC Information with a scan tool. Does the scan tool indicate any failed DTCs? |
Go to Diagnostic Trouble Code (DTC) List - Vehicle in Vehicle DTC Information | Go to Step 4 |
| 4 |
|
Go to Step 5 | Go to Diagnostic Aids |
| 5 | Observe the emission related DTC portion of the I/M System Status display with a scan tool. Does the scan tool indicate any emission related DTCs set? |
Go to Diagnostic Trouble Code (DTC) List - Vehicle in Vehicle DTC Information | System OK |