LEMON Manuals: Even more car manuals for everyone

Cuts Out, Misses

Cuts Out, Misses

Inspections Action
DEFINITION: Steady pulsation or jerking that follows engine speed, usually more pronounced as engine load increases.
Preliminary
Fuel System
Sensor/System
  • Inspect for conditions which cause an incorrect idle speed.
    • Throttle body tampering, excessive deposits, or damage
    • Restricted air intake system.
    • Large vacuum leak
  • Test the throttle position (TP) sensor and related circuit wiring. Refer to DTC P0123 .
  • Test the exhaust gas recirculation (EGR) system for proper operation. Refer to Exhaust Gas Recirculation (EGR) System Description .
  • Test the positive crankcase ventilation (PCV) valve for proper operation.
  • Test the transaxle range switch input with the vehicle in drive and the gear selector in drive or overdrive.
  • Inspect the following for damage:
Ignition System
  • Test for proper ignition voltage output using the following steps:
    1. Clip the J 26792 Spark Tester to engine ground.
    2. Connect one end of a spark plug wire to the J 26792 . Connect the other end of the spark plug wire to the coil being tested.
    3. Connect another spark plug wire between the remaining tower of the coil being tested and ground.
    4. Crank the engine while observing the J 26792 . A spark should be observed.
    5. Repeat the above steps for each coil.
  • If spark is not present at the coils, inspect for the following conditions:
    • Coils-Cracks, carbon tracking/arcing, or a secondary resistance value outside the specified range.

      Coil Resistance:  5000-8000 ohms (5K-8K ohms)

    • IMPORTANT: Spraying the secondary ignition wires with a light mist of water may help locate an intermittent condition. Ignition components will arc to ground when a secondary component is faulty.
    • Spark plug wires-Signs of arcing/cross firing, cracks, carbon tracking, plug boot damage, pinched, improper routing, or a resistance value outside the specified range.

      Spark Plug Wire Resistance:  9840 ohms per meter (3000 ohms per foot)

      Spark Plug Wire Resistance Police:  1,968 ohms per meter (600 ohms per foot)

    • Defective module
    • Ignition system wiring-Loose ignition module feed or ground connection, or damaged system wiring
  • Remove spark plugs and inspect for the following:
    • Fouled plugs
    • Cracks
    • Wear
    • Improper gap
    • Burned or damaged electrodes
    • Improper heat range or reach
  • If spark plugs are gas or oil fouled, the cause of the fouling must be determined before replacing the spark plugs. Refer to Spark Plug Inspection .
  • Test for the following intermittent ignition system conditions:
    • Intermittent CKP 18X signal
    • Intermittent ignition feed circuit or sensor ground circuit to the crankshaft position sensor or the camshaft position sensor
    • Intermittent 3X reference signal
    • Intermittent camshaft position signal
Engine Mechanical Refer to Symptoms - Engine Mechanical in Engine Mechanical - 3.8L.
Additional Inspections
  • Test exhaust system for possible restrictions. Inspect for the following:
    • Inspect exhaust system for damaged or collapsed pipes.
    • Inspect mufflers for heat distress or possible internal failure.
    • For possible plugged 3-way catalytic converter-Refer to Restricted Exhaust in Engine Exhaust.
  • Inspect for intake and exhaust manifold passages for casting flash.
  • Inspect for faulty motor mounts.