Installation Procedure
- Insert the mount stud into the transaxle mount bracket.
- Push up on the frame rail bolts in order to clear the mount (2) as the mount is rotated into the proper position.
- Make sure the loose frame rail bolts are properly aligned with and inserted into the mount.
- Lower the vehicle.
- Install the frame rail bolt retaining screws.
Tighten: Tighten the frame rail bolt retaining screws to 4 N.m (35 lb in).
- Raise the vehicle.
- Install the mount bolt (1) and rotate counter clockwise to ensure anti-rotation tab locks behind mount bracket.
- Install the mount nuts (4) and (3).
Tighten: Tighten the mount nuts (4) and (3) to 70 N.m (52 lb ft).
- Using the transaxle stand, raise the powertrain and load the mount.
- Install the mount stud nut onto the mount stud.
Tighten: Tighten the mount stud nut to 80 N.m (59 lb ft).
- Remove the transaxle stand.
- Install the left front fascia extension. Refer to Fascia Extension Replacement - Front in Bumpers.
- Install the left front tire and wheel. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
- Lower the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
NOTE:
Refer to Fastener Notice
in Cautions and Notices.