LEMON Manuals: Even more car manuals for everyone

Adjustment Procedure

  1. Remove the trim panel. Refer to Trim Panel Replacement - Side Front Door .
  2. Remove the water deflector. Refer to Water Deflector Replacement - Front Door .
    • Condition 2.1:  Using a flat-bladed tool, straighten the run channel lip by pulling it out to its correct position.
    • Condition 2.2:  Use a flat-bladed tool to push the run channel rearward to seat it in the door frame.
      NOTE: Refer to FASTENER NOTICE .
    • Condition 2.3: 
      • Loosen the window to regulator bolts.
      • Rotate the cam (5) on the window regulator plate so that the slot (6) is straight up and down.
      • In this position, the back of the glass will tilt forward.
      • Tighten the 2 window to regulator bolts to 10 N.m (89 in lbs).
    • Fig 1: Identifying Window Regulator Adjuster Cam & Bolts
      G01755882Courtesy of GENERAL MOTORS CORP.
    • Condition 2.4: 
      • Loosen the window to regulator bolts.
      • Loosen the 4 regulator bolts.
      • Now, tighten the window regulator bolts according to the tightening sequence (1,2,3,4).
      • Tighten the 4 window regulator bolts to 10 N.m (89 in lbs).
      • Tighten the 2 window to regulator bolts.
      • Tighten the 2 window to regulator bolts to 10 N.m (89 in lbs).
  3. Connect the power window switch.
  4. Install the water deflector. Refer to Water Deflector Replacement - Front Door .
  5. Install the trim panel. Refer to Trim Panel Replacement - Side Front Door .