LEMON Manuals: Even more car manuals for everyone

Window Regulator Motor: Removal

  1. Remove window regulator. See WINDOW REGULATOR  .
  2. WARNING: This step must be performed when regulator is removed from door. The regulator lift arms are under tension from the counterbalance spring and can cause serious injury if the motor is removed without locking the sector gear in position.
  3. Drill a hole through the regulator sector gear and back plate and install a screw and nut to lock sector gear in position. See Fig 1 . Do not drill hole closer than 1/2" (13 mm) to edge of sector gear or backplate.
  4. Remove rivets holding motor to regulator using a 3/16" drill bit.
Fig 1: Identifying Sector Gear Lock Hole
G00127171Courtesy of GENERAL MOTORS CORP.