LEMON Manuals: Even more car manuals for everyone

Direct Ignition System (DIS)

DIS is a distributorless system used on 2.2L, 2.5L and some 3.1L models. On the 2.3L, a similar system is referred to as the Integrated Direct Ignition (IDI) system. The operation of both systems is quite similar to that of C(3)I system. They consist of 2 or 3 ignition coils (4-cylinder or V6), spark plug wires, ignition module (located under coil pack), a crankshaft position sensor, necessary wiring and the Electronic Spark Timing (EST) portion of the Electronic Control Module (ECM). On 2.3L models, coils, module and spark plug connectors are all combined in one unit which plugs directly onto spark plugs.

Rather than a crankshaft position sensor mounted at crankshaft pulley (such as C(3)I), spark is timed by a signal sent from a crankshaft sensor mounted through side of engine block. This signal is received by ECM (through ignition module) and is used to trigger each coil at the proper time. See CRANKSHAFT POSITION SENSOR in INPUT SIGNALS section of this article. As with the C(3)I system, each cylinder is fired consecutively with the cylinder opposite it in the firing order. On the 3.1L, cylinders No. 1/4, 3/6 and 2/5 are paired. On 2.2L, 2.3L and 2.5L engines, cylinders No. 1/4 and 2/3 are paired. Each pair of cylinders is fired by its own ignition coil.

The crankshaft position sensor is mounted on the bottom of the DIS ignition module or near the ignition module. The sensor protrudes through the side of engine block to within .050" (1.3 mm) of an internally-mounted crankshaft reluctor ring. Sensor position is not adjustable.

The reluctor is a special piece of metal cast with the crankshaft. It has 7 slots machined into it, 6 of which are equally spaced (60 degrees apart). A seventh slot is spaced about 10 degrees from one of the other slots and generates a synchronization pulse signal. As crankshaft rotates, notches in the reluctor ring change the magnetic field at the tip of position sensor. This creates an induced AC voltage signal in the sensor windings, resulting in RPM reference signals which are sent to ECM by ignition module. This allows ECM to compute crankshaft position and RPM, and fire appropriate ignition coil at the proper time.