LEMON Manuals: Even more car manuals for everyone

Valve Housing

  1. Remove protective cap from end of valve housing, then remove housing. Remove the ball bearing.
    Fig 1: Valve Housing Seal Locations
    G09355933Courtesy of BMW OF NORTH AMERICA, INC.
  2. If needle roller bearing is to be replaced: Press off bearing race, then remove the double needle roller cage. Remove bearing race from valve housing with a suitable puller.
    Fig 2: Shaft Bearing Locations
    G09355934Courtesy of BMW OF NORTH AMERICA, INC.
  3. When installing: Install bearing and needle roller cage without play. To accomplish this, the needle roller cages are available in four different sizes.
    CAUTION: Adjust torque value with bearing disc, as outlined under Intermediate Cover below.

    Inspect sealing rings (four used) and replace if necessary. Cover worm shaft splines with Scotch tape to prevent damage to seal when installing housing.