LEMON Manuals: Even more car manuals for everyone

Steering Gear: Installation

  1. With steering gear on bench, remove socket-head bolt (1). See Fig 1. Move rack until centering dimple on rack aligns with threaded hole (2). Install and hand tighten Centering Bolt (VAG 1907) or equivalent.
  2. Position steering gear. Loosely install bolts No. 1 and 2. See Fig 2. Install bolt No. 3 and tighten to specification. See TORQUE SPECIFICATIONS . Tighten bolts No. 1 and 2 to specification.
  3. Using NEW sealing rings, install return and pressure hoses. Before tightening, verify that hoses are set to specified angles. See Fig 3.
  4. Working inside of vehicle, turn key and release steering wheel lock. Center steering wheel. Install universal gear to steering rack. Install adjusting Torx bolt and tighten in counterclockwise direction.
  5. Working under vehicle, remove centering bolt. Install socket-head bolt, and tighten to specification. See TORQUE SPECIFICATIONS .
  6. To finish installation, reverse remaining removal procedure. Tighten nuts and bolts to specification. See TORQUE SPECIFICATIONS . Fill and bleed hydraulic system. See STEERING SYSTEM BLEEDING  under LUBRICATION. Start engine and check for leaks. Check wheel alignment. See SPECIFICATIONS & PROCEDURES article in WHEEL ALIGNMENT.
Fig 1: Installing Centering Bolt
G00203795Courtesy of AUDI OF AMERICA, INC.
Fig 2: Installing Steering Gear Mounting Bolts
G00203796Courtesy of AUDI OF AMERICA, INC.
Fig 3: Power Steering Hose Installation Positions
G00203797Courtesy of AUDI OF AMERICA, INC.