Pin Voltage Charts
NOTE:
All voltage tests should be performed with a Digital Volt-Ohmmeter (DVOM) with a minimum 10-megohm input impedance, unless stated otherwise in testing procedures. Voltage readings may vary slightly due to battery condition or charging rate.
CIS-MOTRONIC VOLTAGE & RESISTANCE TESTS
| Terminals |
Test Conditions |
Test Values |
| 14 & 35 |
Ignition ON |
About Battery Voltage |
| 17 & 35 |
Ignition ON |
About Battery Voltage |
| 32 & 35 |
Ignition & A/C ON |
About Battery Voltage |
| 33 & 35 |
Ignition & A/C ON |
About One Volt Below Battery Voltage |
| 19 & 35 |
Ignition ON |
About Battery Voltage |
| 13 & 35 |
Insert Fuel Relay Fuse, Ignition ON |
CHECK ENGINE Light Must Light |
| 4 & 5 |
Ignition OFF |
15-25 Ohms |
| 3 & 35 |
Ignition OFF |
2500 Ohms @ 68°F (20°C) |
| 3 & 35 |
Ignition OFF |
200 Ohms @ 212°F (100°C) |
| 31 & 35 |
Throttle Closed |
Open (No Continuity) |
| 31 & 35 |
Throttle Wide Open |
Continuity |
| 28 & 35 |
Throttle Closed & Open |
Continuity |
| 18 & 35 |
Ground Test |
Continuity |
| 13 & 35 |
Insert Fuel Relay Fuse |
Continuity |
| 13 & 35 |
Ground Test Connector |
Continuity |
| 14 & 16 |
Cold Start Solenoid Test |
About 10 Ohms |
| 14 & 15 |
Charcoal Canister Solenoid Test |
30-60 Ohms |
| 30 & 35 |
Unplug Hall Effect Sensor Connector Terminals 1 & 2 To Hall Effect Sensor |
Continuity |
| 30 & 21 |
Unplug Hall Effect Sensor Connector Terminals 2 & 3 To Hall Effect Sensor |
Continuity |
| 11 & 35 |
Remove Terminal From Coil Power Output Stage & Ground Center Contact |
Continuity |
| 11 & 35 |
Disconnect Knock Sensor Connector |
Open (No Continuity) |
| 6 & 8 |
Connect Terminals 1 & 2 |
Continuity |
| 6 & 8 |
Connect Terminals 1 & 3 |
Continuity |
| 7 & 35 |
Disconnect O2 Connector & Ground |
Continuity |
| 23 & 26 |
Sensor Plate In Rest Position |
About 5000 Ohms |
| 26 & 35 |
Sensor Plate In Rest Position |
About 4000 Ohms |
| 34 & 35 |
Standard Transmission |
Continuity |
| 34 & 35 |
Auto. Transmission In P Or N |
Open (No Continuity) |
| 12 & 35 |
Remove Fuel Pump Relay & Ground Terminal No. 47 Of Fuse Panel Relay |
Continuity |
Courtesy of AUDI OF AMERICA, INC.