PCM Inspection (1)
NOTICE:
Before disconnecting the PCM connector, jump the SCS line with the HDS, and wait more than 1 minute.
NOTE: Since there is no direct method to test the component itself, troubleshooting is performed on the related components.
Preconditions
- Engine starts
Test Procedure
- Preparation
-
- -
PCM connector A (50P): disconnected
- -
Relay circuit board connector B (12P): disconnected
- -
- Procedure
-
- -
Perform the inspection according to the following table.
Refer to the Open/Shorted Wire Inspection Description for the method to inspect the shorted circuit below, then start to inspect according to circumstances.
- -
(Disconnected) PCM connector A (50P) - Refer to: PCM Connector for Inputs and Outputs (1.5L Engine) or PCM Connector for Inputs and Outputs (2.0L Engine) (2024 2025) female terminals
IG Mode
Normal Conditions
ST_CUT_RLY2_CL- shorted to ground inspection
OFF
There is more than 1 MOhm
Results
- If it is normal, there is a problem with the PCM.
- If it is abnormal, there is a problem with other related components.