DC_STS Circuit Inspection
NOTICE:
Before disconnecting the PCM connector, jump the SCS line with the HDS, and wait more than 1 minute.
Test Procedure
- Preparation
-
- -
DC-DC converter connector A (3P): disconnected
- -
PCM connector A (50P): disconnected
- -
- Procedure
-
- -
Perform the inspection according to the following table.
- -
(Disconnected)DC-DC converter connector A (3P)female terminals
(Disconnected) PCM connector A (50P) - Refer to: PCM Connector for Inputs and Outputs (1.5L Engine) or PCM Connector for Inputs and Outputs (2.0L Engine) (2024 2025) female terminals
IG Mode
Normal Conditions
DC_STS open wire inspection
OFF
There is less than 1 Ohm
Refer to the Open/Shorted Wire Inspection Description
for the method to inspect the shorted circuit below, then start to inspect according to circumstances.
DC_STS shorted to power inspection
ON
Not shorted
Results
- If abnormal, there is a problem in the circuit.