LEMON Manuals: Even more car manuals for everyone

Front Door Latch Replacement

NOTE: Put on gloves to protect your hands.
  1. Remove these items:
  2. Raise the glass fully.
  3. Remove the plastic cover as needed (see step  3).
  4. Release the rod fastener, and disconnect the outer handle rod from the outer handle base (see step  12).
  5. Driver's door: Disconnect the lock cylinder cable from the latch (see step  4).
  6. Pull away the glass run channel (A) as needed, and remove the bolt, then remove the center lower channel (B) by pulling it downward.
    Fig 1: Identifying Glass Run Channel
    G08073598Courtesy of AMERICAN HONDA MOTOR CO., INC.
  7. Remove the screws (A, B) securing the latch (C), then remove the latch through the hole in the door.
    NOTE: Take care not to bend the outer handle rod (D), the latch cable (E), or the inner handle cable (F).
    Fig 2: Outer Handle Rod, Latch Cable, Inner Handle Cable And Screws With Torque Specifications
    G08073599Courtesy of AMERICAN HONDA MOTOR CO., INC.
  8. Remove the foam seals (A, B) from the latch protector (C) and the latch (D).
    Fig 3: Removing Foam Seals From Latch Protector And Latch
    G08073600Courtesy of AMERICAN HONDA MOTOR CO., INC.
  9. Remove the screw, then remove the latch protector (A) as shown.
    Fig 4: Identifying Latch Protector And Screw
    G08073601Courtesy of AMERICAN HONDA MOTOR CO., INC.
  10. Disconnect the latch cable (A) and the inner handle cable (B) from the latch (C).
    Fig 5: Identifying Latch Cable And Inner Handle Cable
    G08073602Courtesy of AMERICAN HONDA MOTOR CO., INC.
  11. Install the latch in the reverse order of removal, and note these items:
    • Before reinstalling the latch protector, clean the latch and latch protector surfaces with isopropyl alcohol where the new foam seals will be attached.
    • After reinstalling the latch protector to the latch, attach the new foam seals to the protector and the latch.
    • If the inner handle cable is damaged or stress-whitened, replace it with a new one.
    • Make sure the connector is plugged in properly, and rod and each cable is connected securely.
    • Make sure the power door lock operates properly.
    • Make sure the plastic cover on the door is installed properly and sealed around its outside perimeter to seal out water.