Front Seat Lumbar Support Replacement
SRS components are located in this area. Review the SRS component locations (see COMPONENT LOCATION INDEX ) and the precautions and procedures (see PRECAUTIONS AND PROCEDURES ) before doing repairs or service.
NOTE:
- Put on gloves to protect your hands.
- Take care not to tear or damage the seat covers.
- Take care not to kink the cable.
- Remove the front seat (see FRONT SEAT REMOVAL/INSTALLATION ).
- Release the hook straps, then pull back the undercover of the seat-back cover (see step 3 on 3 ).
- Remove the back panel (see 4 step 4 on ).
- Release the hook strip as needed, then turn over the seat-back cover (see step 5 on 5 ).
- Release the upper wire (A) from both seat-back side frames (B) of inside the seat-back.
- Release the lower wire (A) from both active head restraint links (B) of inside the seat-back.
- Remove the lumbar support motor cover (A).
- Release the cover from the lower hooks (B).
- Pull the cover upward to release it from the upper hooks (C).
Driver's seat
Passenger's seat
- Disconnect the lumbar support motor connector (A), and detach the harness clip (B). Remove the bolts (C) and the nuts (D, E). And disconnect the ODS unit connector (F) (on passenger's seat), then remove the lumbar support motor (G),
Driver's seat
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Passenger's seat
- Install the lumbar support in the reverse order of removal, and note these items:
- Make sure each connector is plugged in properly.
- To prevent wrinkles when installing a seat-back cover, make sure the material is stretched evenly over the pad before securing the hook strips.
- If the clips are damaged or stress-whitened, replace them with new ones.
- Push the clips and the hooks into place securely.