LEMON Manuals: Even more car manuals for everyone

Ball Joint Boot Inspection/Replacement

Special Tools Required 

  1. Check the ball joint boot for weakness, damage, cracks, and grease leaks
    NOTE:
    • If the ball joint boot is damaged with grease leaks, replace the appropriate part as an assembly
    • If the ball joint boot is soft and cracked without grease leaks, go to step 2 Replace the appropriate ball joint boot
  2. Disconnect the appropriate ball joint connection, and remove the component including the ball joint
  3. Paint a alignment mark (A) in the center between the both boot clip end faces (B) on the appropriate part (C).
    NOTE: When the ball joint boot and the grease are bundled, use the bundled grease.
    Fig 1: Applying Match Mark Onto Ball Joint
    G00500520Courtesy of AMERICAN HONDA MOTOR CO., INC.
  4. Remove the boot clip and the boot
  5. Pack the interior and lip (A) of a new boot with grease Keep the grease off of the boot-to-housing mating surfaces (B)
    Fig 2: Packing Interior And Lip Of Boot With Grease
    G05987733Courtesy of AMERICAN HONDA MOTOR CO., INC.
  6. Pack fresh grease into the base (C) Do not let dirt or other foreign materials get into the boot
  7. Install the boot on the ball joint, then squeeze it gently to force out any air, then wipe the grease off the tapered portion of the ball joint pin (D)
  8. The front knuckle ball joint or the rear upper arm ball joint Adjust the depth by turning the ball joint boot clip guide until its base is just above the groove around (A) the bottom of the boot Then slide the clip (B) over the tool and into position on the boot
    Fig 3: Identifying Positioning Boot Clip Over Tool
    G05987734Courtesy of AMERICAN HONDA MOTOR CO., INC.
  9. The front upper arm ball joint Adjust the ball joint boot clip guide with the adjusting bolt (A) until its base is just above the groove around (B) the bottom of the boot Then slide the clip (C) over the ball joint boot clip guide and into position on the boot
    Fig 4: Identifying Adjusting Bolt, Groove And Clip
    G05987735Courtesy of AMERICAN HONDA MOTOR CO., INC.
  10. Align the center between the both end faces of the boot clip to alignment mark of the appropriate part (see Fig 1).
  11. After installing a boot, wipe any grease off the exposed portion of the ball joint pin
  12. Install all of the removed parts